Teac DM-24 - Manual (Page 29)

4 – Parts of the DM-24—Top surface
TASCAM DM-24 Reference Manual
29
Analog module inputs
These inputs typically feed the first sixteen input
channels, but may be assigned in other ways as
explained in “Setting up the I/O” on page 36.
1 INSERT These TRS 1/4” connectors are used
to provide a post- TRIM insert (send at –2dBu), and
the return (–2dBu) occurring just pre-AD convertor.
2 LINE IN (BAL) These balanced 1/4” jacks
accept analog inputs at a nominal +4dBu input level,
adjustable with the
TRIM controls.
3 MIC These XLR connectors accept analog
inputs for balanced microphones. Phantom power is
available (switchable in groups of 4 inputs).
The input level is adjustable with the TRIM controls.
NOTE
There is no switch to allow a choice between the MIC
and the LINE inputs. Accordingly, connections should
not be made to both inputs of a channel simulta-
neously.
WARNING
4 TRIM These controls allow the input levels
from the MIC and LINE inputs to be adjusted over a
range of 56 dB.
Turning these controls clockwise increases the level
of the signal fed to the channel AD convertors.
5 PHANTOM (+48V) These switches allow
+48V phantom power to be provided to the MIC
channel inputs. These switches are arranged so that
one switch controls the phantom power for four input
channels (1 through 4, 5 through 8, 9 through 12, and
13 through 16).
Other analog I/O
These inputs and outputs provide analog feeds to
monitoring systems, etc.a balanced pair of stereo
master outputs and an insert loop for these outputs.
There are also four assignable sends and returns, as
explained in “Setting up the I/O” on page 36.
6 MONITOR OUTPUTS [CR (BAL)] These
1/4” balanced analog outputs are used to provide
monitoring signals to the control room as selected
using the monitor select switches (+4dBu nominal
level).
7 STEREO OUTPUT This pair of balanced
XLR connectors provides the analog stereo out signal
at +4dBu.
8 MONITOR OUTPUTS [STUDIO] These
unbalanced RCA connectors provide unbalanced sig-
nals to the studio at a nominal output level of
–10dBV.
9 2-TR IN These two RCA unbalanced inputs
are typically used for monitoring the replay from an
analog mastering device at a nominal input level of
–10dBV.
A STEREO OUTPUT [INSERT] These 1/4”
TRS connectors provide insert facilities for the
STEREO OUTPUT s. The send (level –2dBu) is post
DA convertor and the return (level –2 dBu) is imme-
diately before outputs.
1 2 3 4
5
Connection of microphone cables and microphones:
to prevent hazard or damage, ensure that only
microphone cables and microphones designed to the
IEC 268-15A standard are connected.
Connexions des microphones et de leurs câbles: pour
éviter tout endommagement, s’assurer de brancher
uniquement des microphones et des câbles de micro-
phones conçus selon la norme IEC 268-15A.
0 6
8
7
9 w
q e