Teac DM-24 - Manual (Page 100)

13 – Library functions—Managing library entries
100
TASCAM DM-24 Reference Manual
If the currently-selected entry is read-only
(the inverse
R is shown), an appropriate error
message is displayed and the data is not
stored.
If data already exists in the library entry, a
popup message appears to show that data is
already there and will be overwritten.
3 In the case of overwriting an existing entry,
press
ENTER to overwrite the entry, or any of
the cursor keys to cancel the operation.
Storing entries in a non-active library
When a library has not been set as active, the dedi-
cated library screen must be used.
1 With the SHIFT indicator off, press LIBRARY
(key 7 on the numeric keypad). The screen
corresponding to the last library used
appears.
2 To change the library, press soft key 1 so that
a pull-up menu containing the different
libraries appears. Turn POD 1 to highlight
the library that is to store the data, and press
ENTER .
The screen changes depending on the
selected library, as a “preview” of the
selected entry is shown, and the way in which
this preview is displayed changes according
to the library.
3 Use POD 4 to scroll up and down through the
list of entries. Read-only entries are marked,
and entries which contain data are titled.
4 When the entry where the current data is to
be stored is highlighted, press the second soft
key (
STORE ) or the dedicated STORE key.
If the currently-select entry is read-only (the
inverse
R is shown), an appropriate error
message is displayed and the data is not
stored.
If data already exists in the library entry, a
popup message appears to show that data is
already there and will be overwritten.
5 Overwrite existing entries using the ENTER
key.
6 When a library entry is to be stored, it must
be named. See below for details of naming
entries.
Loading entries from an active library
When a library has been made active, you can recall
entries in the library from almost any screen.
1 Use the + and – keys to the left of the display
to change the library entry number shown at
the top of the screen.
2 Press the RECALL key below the + and – keys
to recall the library entry and overwrite the
current settings.
If there is no data in the library entry, a
popup message appears to show this, and no
data is recalled.
NOTE
Recalling library entries, especially if you are unsure of
the contents of the entry, may result in unexpected
changes of volume. Be prepared for this, and turn down
the monitoring system to avoid damage to your ears
(and the monitoring equipment) if you feel that this
may be a problem.
Loading entries from a non-active library
1 With the SHIFT indicator off, press LIBRARY
(key 7 on the numeric keypad). The screen
corresponding to the last library used
appears.
2 To change the library, press soft key 1 so that
a pull-up menu containing the different
libraries appears. Turn POD 1 to highlight
the library that is to store the data, and press
ENTER .
The screen changes depending on the
selected library, as a “preview” of the
selected entry is shown, and the way in which
this preview is displayed changes according
to the library.