Teac DM-24 - Manual (Page 102)

13 – Library functions—Libraries—snapshots
102
TASCAM DM-24 Reference Manual
Libraries—snapshots
There are a few items regarding the snapshot library
which should be noted:
The snapshot library screen includes a picture of the
faders, together with pan/balance settings and mute
settings.
However, the snapshot itself comprises more than
this. All the parameters listed in “Snapshot “neutral”
setting” on page 102 are stored in a snapshot.
As the list on the right of the screen is scrolled using
POD 4, the snapshot image on the right changes to
show the setting stored in that entry.
The snapshot image on the left shows the current
data.
As well as the snapshot name itself, the entry also
stores whether the snapshot was made at high (96k or
88.2k) or normal sampling frequency.
NOTE
It is not possible to recall a snapshot made at a high
sampling frequency when the DM-24 is in normal sam-
pling frequency mode, or the other way round.
The transition time is also displayed (in seconds).
See above for how to set and store this time.
Protecting snapshot settings
It is possible to protect various aspects of the setup,
to prevent the recalled snapshot from overwriting
them. This means that only the “important” parts of a
snapshot can be used—for example, the I/O and buss
assignments can be retained and not overwritten by
the snapshot.
I/O SEL / BUSS ASSIGN If this is checked, it
allows the I/O selection “Setting up the I/O” on
page 36 to be retained, as well as the buss assignment
settings.
GROUPING If this is checked, when the snapshot
is recalled, the mute and fader groupings are retained.
OTHER If this is checked, other settings will be
retained when a snapshot is recalled.
NOTE
If all these boxes are checked, no settings will be
changed when a snapshot is recalled.
Snapshot “neutral” setting
The snapshot read-only entry is a “neutral” setting.
All faders are set to nominal levels, and pan controls
are set to center, etc.
Specifically
Item Value
EQ switch ON
EQ gain (all bands) 0dB
EQ frequency (LO/LM/LH/HI) 99 Hz/1 kHz/4 kHz/10.1 kHz
EQ Q (LO/LM/LH/HI) L.SHELF/8.65/8.65/H.SHELF
Fader level 0dB
Cut OFF
Aux send levels (all) –
∞
Aux pre/post (Aux 1,2 only) POST
Aux ON/OFF ON
Pan/BAL CENTER
Image width STEREO100%
MONO switch STEREO
Surround L-R CENTER
Surround F-R F45
Surround L-R Div 100%
Surround F-R Div 100%
SUB level 0dB
Aux master levels 0dB
Aux master link OFF
Aux master cut OFF
Buss level 0dB
Item Value