Teac DM-24 - Manual (Page 109)

14 – Surround operations—“Pan” controls
TASCAM DM-24 Reference Manual
109
The screen below shows the 3 + 1 surround assign-
ment settings.
The following screen shows the 5.1 surround assign-
ment settings.
In these screens, the four buss pairs are replaced by
buttons representing the front and rear pairs of speak-
ers (
SRND ) and the center speaker ( C ) for the 3 + 1
and 5.1 modes. The 5.1 mode also includes a buss for
the sub-woofer or “boom” speaker (
B-M) .
The channel can also be output through the usual ste-
reo buss (
ST ).
As in the usual assignment procedure, channels 1
through 16 are also capable of direct output.
Use the SEL keys and cursor keys to select the chan-
nel, and POD 4 to select the output channel, and
make and un-make assignments to the channels using
the
ENTER key.
Soft keys 1 and 2 are used for on-screen buttons,
allowing all channels to be assigned to or de-assigned
from the routing selected by POD 4.
“Pan” controls
The concept of panning does not apply to surround
mixes as it does to stereo mixes.
Accordingly, when a surround mode is selected, the
MODULE screen shows the pan control only for the
left-right pan setting.
To make other surround settings, use the SURROUND
screen.
This screen is accessed by pressing the PAN/BAL –
SURROUND key. Instead of a global screen showing
all modules, the surround screen for the currently-
selected module and one other module is shown.
If a pair of modules has been linked as a stereo pair,
the stereo linking does not apply to the surround set-