QuickLabel Vivo! Touch - Manual (Page 130)

Maintenance
116 Vivo! Touch User Guide
Cleaning the Image Belt Wiper
1 Turn the printer power off and wait for the LED near the touchscreen to turn
amber. Then unplug the AC power cord from the receptacle.
2 Open the top cover of the Vivo! Touch.
3 Grasp the top center area of the image drum and lift it, complete with its toner
cartridge, up and out of the printer.
Place the image drum assembly on a piece of paper to avoid marking your surface
with toner. Store the assembly away from light. Repeat this process for the
remaining image drums.
4 Turn the two blue image belt fasteners counterclockwise. This will release the belt
from the printer chassis. Pull the blue bar on the image belt up and remove the belt
from the printer.
When lifting out the image belt, notice how the drive gear fits into the
corresponding gear in the rear left corner of the printer. This will help you replace
the belt later.