QuickLabel 482 Pronto! User Manual
QuickLabel Equipment

4 8 6 • 4 8 2 • 8 6 3 • 6 8 2
QuickLabel.com
Part Number: 22834571-EN-E | Revision 2.0
Pronto! 486
•
Prints or laminates in
600 dpi at up to 4 ips
Pronto! 482
•
Prints or laminates in
200 dpi at up to 10 ips
Pronto! 863
•
Prints or laminates in
300 dpi at up to 6 ips
on labels up to 8.5” wide
Pronto! 682
•
Prints or laminates in
200 dpi at up to 8 ips
on labels up to 6.5” wide
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1: Introduction & Installation
- Chapter 2: Operating panel
- Chapter 3: Offline menu
- Chapter 4: Device types
- Chapter 5: Configuration
- Chapter 6: Loading media
- Opening and closing the support bracket Pronto! 863
- Loading labels from a roll
- Removing the wound roll
- Loading fanfold labels
- Loading transfer ribbon
- Setting the feed path of the transfer ribbon
- Removing and installing the rewind guide plate, dispense plate or tear-off plate
- Removing and installing the locking system
- Chapter 7: Printing
- Chapter 8: Accessories
- Cutter
- External keyboard
- External Rewinder (ER1)
- External Rewinder (ER4)
- External Unwinder (EU4)
- Safety Instructions
- Delivery Contents
- Placing the Unwinder
- Media Loading
- Preparing the Winding Axle and the Flanges
- Retaining Rolls with 1.56 in (40 mm) Cardboard Core on the Winding Axle
- Retaining Rolls with 3 in (76 mm) Cardboard Core on the Winding Axle
- Insertion of the Prepared Winding Axle
- Adjusting the Unwinder
- Label Present Sensor (PS6)
- Pause Adapter PS7
- WLAN-Card
- External Operating Panel
- Antistatic Brush
- Chapter 9: CU4 Cutter Accessory
- Chapter 10: CS4 Cutter/Stacker Accessory
- Chapter 11: Cleaning and basic maintenance
- Chapter 12: Test functions
- Chapter 13: Service functions
- Chapter 14: FTP printer management
- Chapter 15: Memory media
- Chapter 16: Error treatment
- Chapter 17: Specifications
- Appendix A: Menu Map