QuickLabel CU-30 User Manual
Operation & setup guide

CU-30, CS-40, CTS-45
Operation & Setup Guide
™
Setting up the stacker (CS-40 and CTS-45 only)
Assembing the CU-30, CS-40, or CTS-45
Setting up the cutter unit with the printer
Cutter-stacker adjustments and tag stock
Adjusting the cut-pulse potentiometer
Changing fuses/voltage selection
Removing the side panels and front attachment
Table of contents
Document Outline
- CU-30 Cutter and
- CS-40 / CTS-45 Cutter-Stacker
- Assembing the CU-30, CS-40, or CTS-45
- Setting up the cutter unit with the printer
- Cutter-stacker adjustments and tag stock
- Adjusting the cut-pulse potentiometer
- Changing fuses/voltage selection
- Clearing a cutter-blade jam
- Replacing the cutter blade
- Appendix A: Guidelines for best performance
- Appendix B: Specifications