QuickLabel Vivo! Touch - Manual (Page 116)

Maintenance
102 Vivo! Touch User Guide
7 Open the cutter cover and locate the two media exit bracket thumbscrews. These
thumbscrews fasten the top bracket to the bottom bracket.
Unscrew the thumbscrews to disconnect the top bracket.
8 Access and remove the top bracket (1) from inside the printer. Use a pre-moistened
alcohol cloth to remove adhesive from the top (1) and bottom (2) brackets.
When you are finished cleaning the brackets, let the alcohol dry.
Note: You can also use an adhesive cleaner solvent that is safe for plastic and metal
surfaces.
9
Install the top bracket and fasten it into position using the two thumbscrews.
10 Lower the image belt into place, with the blue bar at the front and the drive gear
towards the rear of the printer. Insert the drive gear into the corresponding gear in
the rear left corner inside the printer. Lower the belt flat inside the printer.
Turn the two blue image belt fasteners clockwise. This will lock the belt to the
printer chassis.
11 Replace the four image drums, complete with their toner cartridges, into the
printer in the correct sequence: cyan (nearest the media exit), magenta, yellow, and
black (nearest the media entry).
Note: Color labels are located next to each image drum/cartridge slot. These labels indicate
the correct location for each color.