Maintenance, Maintenance recommendations, End-of-roll tasks – QuickLabel Vivo! Touch User Manual
Page 113: Related topics, Every 6 - 8 hours of printing or as needed, Every 20 hours of printing or as needed, Other tasks, Chapter: 8
Vivo! Touch User Guide
99
8
Maintenance
Maintenance Recommendations
The touchscreen indicates most maintenance situations such as low toner, image
drums requiring replacement, etc. However, you can also perform routine
maintenance tasks to improve the performance of the Vivo! Touch.
End-of-Roll Tasks
You should perform the following tasks after each roll of labels:
•
Inspect the feeder rollers and media exit bracket for excess adhesive and clean if
necessary.
Related Topics:
- Cleaning Excess Adhesive from the Feeder Rollers on page 100
- Cleaning Excess Adhesive from the Feeder Media Exit Bracket on page 100
Every 6 - 8 Hours of Printing or as Needed
You should perform the following tasks after every 6 - 8 hours of printing or as needed:
•
Clean the LED arrays with a pre-moistened alcohol cloth.
•
Clean adhesive from the cutter slot.
•
Inspect the image belt and fuser for excess adhesive and clean if necessary.
Related Topics:
- Cleaning LED Arrays on page 111
- Cleaning Excess Adhesive from the Image Belt on page 103
- Cleaning Excess Adhesive from the Fuser on page 104
- Cleaning Excess Adhesive from the Cutter Slot on page 107
Every 20 Hours of Printing or as Needed
You should perform the following tasks after every 20 hours of printing or as needed:
•
Vacuum the interior of the printer with the QuickVac.
•
Inspect the image belt for wrinkles and creases.
•
Clean electrical contacts
•
Vacuum the feeder unwind area with the QuickVac.
Related Topics:
- Vacuuming the Printer Interior on page 108
- Inspecting the Image Belt on page 112
- Cleaning Electrical Contacts on page 114
Other Tasks
You should perform the following tasks as needed:
•
Clean the touchscreen as needed.