Utility:interface:rts tx-if cntrl, Utility:interface:tx data phase, Utility:interface:rx data phase – Comtech EF Data SNM-1010L User Manual
Page 99: Utility:interface:cts delay, Utility:network
SNM-1010L Data/Control Modem
Revision 0
Front Panel Operation
MN/SNM1010L.OM
Upon entry, the framing type (T1 or E1) is displayed on Line 1. The framing structure of
each type (NONE or G.704) is displayed on Line 2. Press [
←] or [→] and [↑] or [↓] to
select framing structure and type. Press [ENTER] to execute the change.
3.4.5.6.7
UTILITY:INTERFACE:RTS TX-IF CNTRL
RTS TX-IF CNTRL
OFF
Programs the modem to allow a Request To Send (RTS) signal to enable the output when
data is ready for transmission.
Press[
←], [→], [↑], or [↓] to move the flashing cursor. Press [ENTER] to execute the
change.
3.4.5.6.8
UTILITY:INTERFACE:TX DATA PHASE
TX DATA PHASE
NORMAL
TX data phase relationship. Use this option to select Normal or Invert for the TX data
relationship to the selected TX clock.
Upon entry, press [
↑] or [↓] to make the selection. Press [ENTER] to execute the change.
3.4.5.6.9
UTILITY:INTERFACE:RX DATA PHASE
RX DATA PHASE
NORMAL
RX data phase relationship. Use this option to select Normal or Invert for the RX data
relationship to the selected RX clock.
Upon entry, press [
↑] or [↓] to make the selection. Press [ENTER] to execute the change.
3.4.5.6.10 UTILITY:INTERFACE:CTS
DELAY
CTS DELAY
3–51