Comtech EF Data SNM-1010L - Manual (Page 234)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
A.9 Miscellaneous
Change Status
Status:
Response: MC CS_'cr'
CS_x'cr''lf']
This command indicates that a change has or has not occurred on
either the BCS_ or the BCSF_ response since the last BCS_ or
BCSF_ poll.
Where: the x character is defined as follows:
@ = no change since last BCS_ and BCSF_ polls.
A = BCS_ response has changed since last BCS_ poll.
B = BCSF_ response has changed since last BCSF_ poll.
C = Both responses have changed since last BCS_ and
BCSF_ polls.
Equipment Type
Status:
Response: MC ET_'cr'
ET_tttttttt_xxx.yyy.zzz'cr''lf']
This command returns the equipment type and the software version
of the addressed device.
Where:
tttttttt = Equipment type.
xxx.yyy.zzz = Software version.
Modem Monitor and
Control Firmware
Information
Status:
Response: MC MCFI_'cr'
MCFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']
Where:
xxx.yyy.zzz = Software version number (0.0.0 to 999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
Modem Data ROM
Firmware Information
Status:
Response: MC DFI_'cr'
DFI_'cr'
DSP_FW/nnnnnn-ddr'cr'
DSP_mm/dd/yy'cr'
FPGA_FW/nnnnnn-ddr'cr'
FPGA_mm/dd/yy'cr''lf']
Where:
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
Notes:
1. If dash number is not used, ‘-dd’ will be reported.
2. Turbo FW information is only returned if Turbo Codec
is installed.
Boot M&C Firmware
Information Status:
Response: MC BFI_'cr'
BFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']
Where: xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
A–36