Comtech EF Data SNM-1010L User Manual
Page 216
SNM-1010L Data/Control Modem
Revision 0
Remote Control Channel Commands/Responses
MN/SNM1010L.OM
RCCL_n’cr’
RCSB_n’cr’
ROCP_xxxx’cr’
RCT_xxxxx’cr
LPC_xxx’cr’
NOMP_snn.n’cr’
MINP_snn.n’cr’
MAXP_snn.n’cr’
LCL_xxxx’cr’
RCL_xxxx’cr’
ENSP_nn.n’cr’
MAXT_n.n’cr’
RTSM_xxx’cr’
CTSD_xx’cr’’lf’]
ASYNC RX Channel Char Length
ASYNC RX Stop Bits
ASYNC RX Overhead Channel Parity
ASYNC RX Communications Type
AUPC Local Power Enable
AUPC Nominal Power Value
AUPC Minimum Power Value
AUPC Maximum Power Value
AUPC Local Carrier Loss
AUPC Remote Carrier Loss
AUPC EBNO Target Set Point
AUPC Max. Tracking Rate
RTS TX Control Mode
CTS Delay Time
This command is used by the Comtech EF Data M:N
protection switch to collect information necessary for
configuring backup modems.
Notes:
1. Status only returned in Transmit
Continuous
mode.
2. Status only returned in Transmit
Burst
mode.
Current Receive Reed-
Solomon N/K and
interleave Value
Status:
Response:
MC RXRS_’cr’
RXRS_nnn/kkk_ii’cr’’lf’]
Where: nn = N value, kkk = K value and ii = Interleave
value
Descrambler Type
Status:
Response:
MC DSCR_’cr’
DSCR_xxxxxxxxxxxx’cr’’lf’]
Where: xxxxxxxxxxxx = IBS SYNC, EFD MOD V.35,
INTELSAT V.35, FDC MOD V.35, ITU V.35 or OFF.
A–18