Comtech EF Data SNM-1010L - Manual (Page 222)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
Current Sweep Value
Status:
Response: MC CSV_'cr'
CSV_xsnnnnn’cr’
CD_yyy'cr''lf] Where: x = < or > (data modifier to indicate that the sweep
offset value is less than or greater than the returned value).
s = + or - (sweep offset from center).
nnnnn = 0 to 75000.
yyy = OK or FLT (decoder lock status OK or FAULT).
Notes:
The 'x' (< or >) parameter is only returned if the level has
exceeded the computational resolution of the system.
'No Data' is returned if the level cannot be calculated.
'Sampling' is returned if not enough data is currently
available to calculate the level.
A.8 Stored Faults
Information on stored faults is returned when requested. If no stored fault exists for a given
fault number, the words ‘NO FAULT’ will be returned instead of the normal time/date and
status information.
The following symbols are used to define the stored faults status commands.
• # Fault number (0 through 9), '0' is the first fault stored.
• hh Hours in 24-hour format.
• mm Minutes.
• ss Seconds.
• MM Month.
• DD Day.
• YYYY Year.
Modulator Stored
Faults Status:
Response:
MC MSF_#'cr'
MSF_# hh:mm:ss MM/DD/YY'cr'
MOD_xxx'cr'
SYN_xxx'cr'
DCS_xxx'cr'
ICH_xxx’cr’
QCH_xxx’cr’
AGC_xxx'cr'
SCT_xxx’cr’
EXT_xxx’cr’
CONF_xxx’cr’’lf’]
Module (OK/FLT).
IF Synthesizer (OK/FLT).
Data Clock Synthesizer (OK/FLT)
I Channel (OK/FLT).
Q Channel (OK/FLT).
AGC Level (OK/FLT).
Modem Reference PLL Lock (OK/FLT).
Modem Reference Activity (OK/FLT).
Configuration (OK/FLT).
A–24