Comtech EF Data SNM-1010L - Manual (Page 235)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
Modem Options
Status:
Response:
MC MOI_'cr'
MOI_'cr'
s,HGH_PWR'cr'
s,HGH_STAB'cr'
s,ASLT'cr'
s,VIT'cr'
s,SEQ'cr'
s,SR'cr'
s,LRV'cr'
s,FRV'cr'
s,CARD_1_PCB'cr'
s,CARD_2_PCB'cr'
s,CARD_3_PCB'cr'
s,8PSK_2/3'cr'
s,TX_ONLY'cr'
s,RX_ONLY'cr'
s,OQPSK’cr’
s,TX_L-BAND’cr’’If’]
(0 or +) High Power
(0 or +) High Stability
(- or +) Asymmetrical Loop Timing
(- or +) Viterbi Encoder/Decoder
(- or +) Sequential Encoder/Decoder
(- or +) Single Code/Data Rate
(- or +) Low Rate Variable
(- or +) Full Rate Variable
(x or +) Card #1 Installed
(x or +) Card #2 Installed
(x or +) Card #3 Installed
(- or +) 8PSK 2/3 Code Rate
(0 or +) TX Only Operation
(0 or +) RX Only Operation
(O or +) OQPSK 1/2, 3/4, 7/8
(0 or +) TX L-Band modem
Notes:
1. s = 0 (Not Installed, Not Upgradable).
2. - (Not Installed, FAST Upgradable).
3. +
(Installed).
4. X (Not Installed, Field Upgradable).
Card #1 Type
Information Status:
Response:
MC C1TI_'cr'
C1TI_'cr'
ttttt'cr''lf'] Where: ttttt = type (DAC_01)
Card #2 Type
Information Status:
Response: MC C2TI_'cr'
C2TI_'cr'
tttt'cr''lf'] Where: tttt = type (RS_02, RS_03, TURBO, or
NOT_INSTALLED).
Card #3 Type
Information Status:
Response: MC C3TI_'cr'
C3TI_'cr'
tttt'cr''lf'] Where: tttt = type (RS_02, RS_03, TURBO, or
NOT_INSTALLED).
Card #2 Options/ Status:
Response: MC C2OI_'cr'
C2OI_'cr'
RS_02 list:
s,INTELSAT'cr'
s,AUPC'cr''lf'] (see Note 4)
RS_03 list:
s,INTELSAT'cr'
s,AUPC'cr''lf'] (see Note 4)
(- or +)
(- or +)
(- or +)
(- or +)
Notes:
1. Card #2 Installed Only.
2. s = - (Not Installed, FAST Upgradable).
3. + = (Installed).
4. AUPC not applicable if TURBO card installed.
A–37