Comtech EF Data SNM-1010L - Manual (Page 108)

SNM-1010L Data/Control Modem Revision 0
Front Panel Operation MN/SNM1010L.OM
3.4.5.9.2 UTILITY:MODEM TYPE:REVISION EMULATION
REV EMULATION
CURRENT VERSION
Programs an emulation mode of a previous functional revision. This allows the user to
select the CURRENT VERSION or FUNCTIONAL X.
Note: The number displayed in the CURRENT VERSION position increases with each
software version change.
Upon entry, the CURRENT VERSION is displayed. Press [
↑] or [↓] to select the
FUNCTIONAL version. Press [ENTER] to execute the change.
Notes:
1.
Programming a current version (default) allows all features and options (if
installed) to operate normally.
2. Programming a FUNCTIONAL version (X) eliminates any changes that affect
the later version. Only functional changes are affected by the revision emulation
feature.
3. A correction change (e.g., VER 3.1.2) remains fixed in accordance with the latest
version. Since the revision emulation default is the current version, program the
functional version at the start of each operation.
4. The revision emulation feature does not affect some interface changes for the
direct operation of the modem (Configuration save/recall, test mode screen in the
Utility/System, all factory setup modes, etc.).
3–60