Utility:system:year display, Utility:system:test mode status, Utility:system:lamp test – Comtech EF Data SNM-1010L User Manual
Page 103
SNM-1010L Data/Control Modem
Revision 0
Front Panel Operation
MN/SNM1010L.OM
OPERATION MODE
DUPLEX
Programs the modem for DUPLEX, TRANSMIT ONLY, or RECEIVE ONLY operation.
Upon entry, the operational status may be changed. Press [
↑] or [↓] to make the selection.
Press [ENTER] to execute the change.
Note: When TRANSMIT ONLY or RECEIVE ONLY are selected, the appropriate faults
are masked from the Faults and Stored Faults menus.
3.4.5.8.6 UTILITY:SYSTEM:YEAR
DISPLAY
YEAR DISPLAY
2 - DIGIT
Selects the display for the year in either 2-digit or 4-digit format.
Upon entry, the year display may be changed. Press [
↑] or [↓] to make the selection. Press
[ENTER] to execute the change
3.4.5.8.7
UTILITY:SYSTEM:TEST MODE STATUS
TEST MODE STATUS
---------
Test mode status indicator. The following modem test points are listed and display a “+”
when a test mode is active:
• RS CORR OFF
• INTRFC LOOP BACK
• B-BAND LOOP BACK
• CARRIER MODE
• RX 2047 Pattern
• TX 2047 Pattern
• IF LOOP BACK
To view the test modes, press [ENTER]. Press [
↑] or [↓] to make the selection.
3.4.5.8.8
UTILITY:SYSTEM:LAMP TEST ??
3–55