Comtech EF Data SNM-1010L - Manual (Page 215)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
RDP_xxxx’cr’
IDF_xxxxxx’cr’
ICRC_xxx’cr’
IBS_nnnnnn’cr’
BICA_dd;cc-dd;cc…’cr’
DSR_xxx’cr’
RSDE_xxx’cr’
RXDR_xxxxxx’cr’
ROBR_nnnnn’cr’
RCCL_n’cr’
RCSB_n’cr’
ROCP_xxxx’cr’
RCT_xxxxx’cr
ENSP_nn.n’cr’
MAXT_n.n’cr’
RDA_xxx’cr’
RRSI_xx’cr’
R310_xxx’cr’
LNB_xxx’cr’
LNBV_xxx’cr’
LNBR_xxx’cr’
LNBL_xxx’cr’
LNBH_xxx’cr’
RX Data Phase
Insert Data Format
Insert E1 CRC Enable
Interface Buffer Size
Bulf Insert Channels Assignment
Demodulator Spectrum Rotation
Reed-Solomon Decoder
Receive Driver Type
ASYNC RX Overhead Baud Rate
ASYNC RX Channel Char Length
ASYNC RX Channel Stop Bits
ASYNC RX Overhead Channel Parity
ASYNC RX Communications Type
AUPC EBNO Target Set Point
AUPC Max. Tracking Rate
RX BPSK Data Ordering
RX Reed-Solomon Interleave Value
RX 8PSK 2/3 IESS-310 Operation
LNB Power
LNB Voltage
LNB Reference
LNB Monitor Low Current Threshold
LNB Monitor High Current Threshold
This command is used by the Comtech EF Data M:N
protection switch to collect information necessary for
configuring backup modems.
Notes:
1. Status only returned in Transmit
Continuous
mode.
2. Status only returned in Transmit Burst
mode.
Interface Configuration
Status Status:
Response: MC ICS_'cr'
ICS_'cr'
TC_xxxx’cr’
ERF_nnnnn.n’cr’
TCP_xxxx’cr’
RCP_xxxx’cr’
BBL_xxx’cr’
ILB_xxx’cr’
ILT_xxx’cr’
ICFT_xxxx’cr’
ICFR_xxxx’cr’
BC_xxx’cr’
IRFR_T1_xxxx’cr’
ICFR_E1_xxxx’cr’
IBP_xxx’cr’
IBS_nnnnnn’cr’
ITOT_xxxxx’cr’
IROT_xxxxx’cr’
ISP_xxxxxx’cr’
IRE_xxxxxx’cr’
TDF_xxxx’cr’
RDF_xxxx’cr’
TDP_xxx’cr’
RDP_xxx’cr’
DDF_xxxxxx’cr’
TXDR_xxxxxx’cr’
RXDR_xxxxxx’cr’
TOBR_nnnnn’cr’
TCCL_n’cr’
TCSB_n’cr’
TOCP_xxxx’cr’
TCT_xxxxx’cr’
ROBR_nnnnn’cr’
TX Clock (Source)
External Reference Frequency
TX Clock Phase
RX Clock Phase
Baseband Loopback
Interface Loopback
Interface Loop Timing
Interface Coding Format Transmit
Interface Coding Format Receive
Buffer Clock (Source)
Interface Receive T1 Frame Structure
Interface Receive E1 Frame Structure
Interface Buffer Program
Interface Buffer Size
Interface Transmit Overhead Type
Interface Receive Overhead Type
Interface Sub Pattern (TX 2047)
Interface Read Error (RX 2047)
TX Data Fault
RX Data Fault
TX Data Phase
RX Data Phase
Drop Data Format
TX Driver Type
RX Driver Type
ASYNC TX Overhead Baud Rate
ASYNC TX Channel Char Length
ASYNC TX Stop Bits
ASYNC TX Overhead Channel Parity
ASYNC TX Communications Type
ASYNC RX Overhead Baud Rate
A–17