Comtech EF Data SNM-1010L - Manual (Page 230)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
98
99
100
101
102
103
104
105
106
107
108
109
110
111
(ref. ‘CTSD_’command).
Carrier Only Mode
(ref. ‘COM_’command).
TX REED-Solomon Interleave Value
(ref. TRSI_’command)
TX 8PSK 2/3 IESS-310 Operation
(ref. ‘T310_’command).
RX 8PSK 2/3 IESS-310 Operation
(ref. ‘R310_’command).
LNB Power
(ref. ‘LNB_’command).
LNB Voltage
(ref. ‘LNBV_’command).
LNB Reference
(ref. ‘LNBR_’command)
LNB Current Monitor Low Threshold
(ref. ‘LNBL_’command)
LNB Current Monitor High Threshold
(ref. ‘LNBH_’command)
ODU Power
(ref. ‘ODU_’command).
FSK Link
(ref. ‘FSKL_’command).
ODU Reference
(ref. ‘ODUR_’command).
ODU Current Monitor Low Threshold
(ref. ‘ODUL_’command).
ODU Current Monitor High
Threshold
(ref. ‘ODUH_’command).
p98 = n, where ‘n’ is ‘0’ (OFF), ‘1’ (CENTER-CW),
‘2’ (DUAL-CW), or ‘3’ (OFFSET-CW).
p99 = nn, where ‘nn’ is the Interleave value.
p100 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p101 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p102 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p103 = n, where ‘n’ is ‘0’ (13 Volts), ‘1’ (18 Volts), or ‘2’
(24 Volts).
p104 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p105 = nnn, where ‘nnn’ is within 0 to 500 mA.
p106 = nnn, where ‘nnn’ is within 0 to 500 mA.
p107 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p108 = n, where ‘n’ is ‘0’ (OFF) or ‘1’ (ON).
p109 = nnnn, where ‘nnnn’ is within 0 to 4000 mA.
p110 = nnnn, where ‘nnnn’ is within 0 to 4000 mA.
p111 = nnnn, where ‘nnnn’ is within 0 to 4000 mA.
Notes:
1. Parameters only valid in Transmit and Receive Continuous mode.
2. Parameters only valid in Transmit Continuous mode.
3. For any parameter other than the last parameter that is not returned, a comma (',') will be returned.
A–32