Comtech EF Data SNM-1010L - Manual (Page 66)

SNM-1010L Data/Control Modem Revision 0
Front Panel Operation MN/SNM1010L.OM
3.4.1.2.14 Configuration:Demodulator:RS Decoder
RS DECODER
OFF
Note: Reed-Solomon option only.
Displays the RS decoder status, either On or Off. Press to execute the change.
Upon entry, the status of the Reed-Solomon decoder is displayed Use [
↑ ] or [↓ ] to select
one of the following modes:
On Enables the Reed-Solomon decoder to provide data error corrections.
Correction _Off Turns Off the Reed-Solomon decoder data error correction circuitry.
Data flow is then routed through normal data paths without error
corrections. This is used to compare the BER of a SATLINK with or
without Reed-Solomon decoding.
Off Reed-Solomon is Off when the modem is operating in “Control
Mode.” To execute any of the Reed-Solomon decoder modes, enter
the desired Reed-Solomon decoder and select the desired mode.
3–18