Comtech EF Data SNM-1010L - Manual (Page 226)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
Demod IF Frequency
(ref. 'DF_' command).
Demodulator Rate
(ref. 'DR_' command).
Demodulator Preset A
(ref. 'ADRA_' command).
Demodulator Preset B
(ref. 'ADRB_' command).
Demodulator Preset C
(ref. 'ADRC_' command).
Demodulator Preset D
(ref. 'ADRD_' command).
Demodulator Preset V
(ref. 'ADRV_' command).
Descrambler Enable
(ref. 'DE_' command).
Diff Decoder Enable
(ref. 'DDEC_' command).
RF Loopback
(ref. 'RFL_' command).
IF Loopback
(ref. 'IFL_' command).
Sweep Center Frequency
(ref. 'SCF_' command).
Sweep Width Range
(ref. 'SWR_' command).
BER Threshold
(ref. 'BERT_' command).
Demodulator Type
(ref. 'DT_' command).
Demodulator Decoder Type
(ref. 'DDT_' command).
Receive BPSK Data
(ref. 'RDA_' command).
Transmit Clock Source
(ref. 'TC_' command).
p17 = nnn.nnnn, demodulator IF frequency in MHz.
p18 = nnnn_mmm.mmm, code rate/data rate in kbps.
p19 = nnnn_mmm.mmm, code rate/data rate in kbps.
p20 = nnnn_mmm.mmm, code rate/data rate in kbps.
p21 = nnnn_mmm.mmm, code rate/data rate in kbps.
p22 = nnnn_mmm.mmm, code rate/data rate in kbps.
p23 = nnnn_mmm.mmm, code rate/data rate in kbps.
p24 = n, where 'n' is '0' (OFF) or '1' (ON).
p25 = n, where 'n' is '0' (OFF) or '1' (ON).
p26 = n, where 'n' is '0' (OFF) or '1' (ON).
p27 = n, where 'n' is '0' (OFF) or '1' (ON).
p28 = snnnnn, sweep center frequency in Hz.
p29 = nnnnn, sweep range in Hz.
p30 = xxxx, BER threshold.
p31 = n, where 'n' is '0' (EFD), '1' (INTL), '2' (CSC), or '3'
(FDC).
p32 = n, where 'n' is '0' (SEQ) or '1' (VIT).
p33 = n, where 'n' is '0' (NRM),or '1' (INV).
p34 = n, where 'n' is '0' (INT), '1' (REF), or '2' ( EXT).
A–28