Comtech EF Data SNM-1010L - Manual (Page 106)

SNM-1010L Data/Control Modem Revision 0
Front Panel Operation MN/SNM1010L.OM
3.4.5.8.16 UTILITY:SYSTEM:MASTER RESET
MASTER RESET
HARD/SOFT
Initiating a hard reset will reset the modem and place the
default configuration settings in ROM. Initiating a soft reset
will reset the modem hardware, but saves the current
configuration settings
.
Select [ENTER] once to access HARD or SOFT.
Press [
←] or [→] to make the selection. Press [ENTER].
Press [ →] five times to move the cursor to YES. Select YES and press [ENTER] again.
Note: The following parameters do not revert to default settings after a hard reset:
• Address
• Parity
• Baud Rate
• Remote Type
• Ext AGC: Min Pwr
• Ext AGC: Max Pwr
• Display Contrast
3–58