Configuration:interface:buffer clock, Configuration:interface:rx clock phase, 4 configuration:interface:buffer clock – Comtech EF Data SNM-1010L User Manual
Page 69: 5 configuration:interface:rx clock phase
SNM-1010L Data/Control Modem
Revision 0
Front Panel Operation
MN/SNM1010L.OM
3.4.1.3.4 CONFIGURATION:INTERFACE:BUFFER
CLOCK
BUFFER CLOCK
RX (SATELLITE)
Programs the interface buffer output clock to one of the following modes:
RX (SATELLITE)
Sets the output buffer clock to the satellite clock. (This is a
Bypass.)
SCT (INTERNAL)
Sets the buffer clock to operate from the modem internal
clock. This is also the fallback clock.
EXT. CLOCK
Sets this clock source to the external clock.
TX TERRESTRIAL
Sets the buffer output clock to recover timing from the
incoming TX data clock.
Upon entry, the current setting of the plesiochronous buffer clock is displayed. Press [
↑] or
[
↓] to make the selection. Press [ENTER] to execute the change.
3.4.1.3.5
CONFIGURATION:INTERFACE:RX CLOCK PHASE
RX CLOCK PHASE
NORMAL
Programs the RX clock phase to Normal or Inverted.
Upon entry, the status of the RX Clock is displayed. Press [
↑] or [↓] to make the selection.
Press [ENTER] to execute the change.
3–21