Queries, Node address (na), Command format – Comtech EF Data SNM-1010L User Manual
Page 139: Local command responses, 7 queries, 4 node address (na), 1 command format, 2 local command responses
SNM-1010L Data/Control Modem
Revision 0
User Port Operation
MN/SNM1010L.OM
4.3.3.7 Queries
The interface can be queried by issuing a valid command without a value at the end. This
will result in the return of the currently set value.
Example (assume a previously sent command as shown):
ICF
1078.4567'cr'
— sets inbound control IF frequency to 1078.4567 MHz.
Now a query:
ICF'cr'
Response from interface:
ICF 1078.4567
— inbound control IF frequency is 1078.4567 MHz.
4.3.4 Node
Address
(NA)
This command sets the node number for the remote control channel mode SNM-1010L
controller.
4.3.4.1 Command
Format
NA
Range of 1 to 9999 and must be unique in the network.
Unpredictable results will occur if two nodes are online and both have been
assigned the same node number.
The node number will generally be defined by the provisioning documents that
establish remote sites and circuits.
4.3.4.2
Local Command Responses
node address =
4–5