Comtech EF Data SNM-1010L - Manual (Page 212)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
A.4 Configuration Status
Modulator
Configuration
Status Status:
Response: MC MCS_'cr'
MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnn'cr'
MR_nnnn_mmm.mmm'cr'
AMRA_nnnn_mmm.mmm'cr'
AMRB_nnnn_mmm.mmm'cr'
AMRC_nnnn_mmm.mmm'cr'
AMRD_nnnn_mmm.mmm'cr'
AMRV_nnnn.mmm.mmm'cr'
MPO_snn.n'cr'Modulator
MOP_snnn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxx'cr'
MET_xxx'cr'
TDA_xxx'cr' (Note
1)
COM_xxx'cr'
TXM_xxxxx'cr'
MPRE_n'cr' (Note
2)
RSEN_xxx'cr' (Note 1)
TDA_xxx’cr’
TRSI_xx’cr’
T310_xxx’cr’
ODU_xxx’cr’
ODUR_xxx’cr’
ODUL_xxxx’cr’
ODUH_xxxx’cr’’lf’]
RF Output (ON/OFF)
Modulator Frequency
Modulator Rate
Preset A Assignment
Preset B Assignment
Preset C Assignment
Preset D Assignment
Preset V Assignment
Power Offset
Modulator Output Power
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Modulator Type
Modulator Encoder Type
TX BPSK Data Ordering
Carrier Only Mode (ON/OFF)
TX Mode
Modulator Preamble
Reed-Solomon Encoder
TX BPSK Data Ordering
TX Reed-Solomon Interleave Value
TX 8PSK 2/3 IESS-310 Operation
Outdoor Unit Power
Outdoor Unit Reference
Outdoor Unit Current Monitor Low Threshold
Outdoor Unit Current Monitor High Threshold
The modulator configuration status command causes a
block of data to be returned by the addressed modem.
Notes:
1. Status only returned in Transmit Burst mode.
2. Status only returned in Transmit
Continuous mode.
A–14