Comtech EF Data SNM-1010L - Manual (Page 218)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
Common Equipment
Status Status:
Response:
MC CES_'cr'
CES_'cr'
M&C_xxx'cr'
INT_xxx'cr'
BAT_xxx'cr'
+5_xxx'cr'
+12_xxx'cr'
-12_xxx'cr'
MODE_xxxxxx'cr'
SFLT_xx'cr''lf']
M&C Module (OK/FLT)
Data Interface Module (OK/FLT)
Battery/Clock (OK/FLT)
+5V Power Supply (OK/FLT)
+12V Power Supply (OK/FLT)
-12V Power Supply (OK/FLT)
Mode (LOCAL or REMOTE)
Number of Stored Faults
Logged (0 through 10)
The common equipment status command causes the
return of a block of data indicating the common
equipment status.
A.6 ODU Configuration Status
Outdoor Unit Status
Status:
Response:
MC OUS_'cr'
OUS_'cr'
CURRENT_xxx'cr'
VOLTAGE_xxx'cr'
TEMP_xxx’cr’
PLL_xxx’cr’
CKSUM_xxx’cr’
SFLT_xx'cr''lf']
Current (FLT/OK)
Voltage (FLT/OK)
Temperature (FLT/OK)
Phase Lock Loop (FLT/OK)
Checksum (FLT/OK)
Number of stored faults logged (0 to 10)
Outdoor Unit
Temperature
Status:
Response:
MC ODUT_'cr'
ODUT_'cr'
ODU_sxx_yyy'cr’’lf'] Where s = + or – sign, xx = 0 to 99 degree in C and
yyy = OK or OOR (Out of Range).
Outdoor Unit Phase
Lock Loop
Status:
Response:
MC OPLL_'cr'
OPLL_xxxxxxxx'cr’’lf'] Where xxxxxxxx = UNLOCKED or OK.
Outdoor Unit Software
Version
Status:
Response:
MC OSV_'cr'
OSV_xxcr’’lf'] Where xx = 0 to 15.
Outdoor Unit Power
Class
Staus:
Response:
MC OPC_'cr'
OPC_xxcr’’lf'] Where xx = 2 to 60 Watts.
Outdoor Unit Address
Status:
Response:
MC OADR_'cr'
OADR_xxcr’’lf'] Where xx = 1 to 15.
Outdoor Unit TX
Output
Status:
Response:
MC ODUO_'cr'
ODUO_xxcr’’lf'] Where xxx = ON or OFF.
Outdoor Unit Power
Leveling
Status:
Response:
MC ODUP_'cr'
ODUP_xxcr’’lf'] Where xxx = ON or OFF.
A–20