Comtech EF Data SNM-1010L - Manual (Page 225)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
Bulk Consolidated
Status Status:
Response:
MC BCS_'cr'
BCS_p1,p2,p3, . . . pn'cr''lf']
This command causes bulk modem status to be returned.
To reduce the length of the response, message parameter data
are returned without identifiers. However, parameter
identification can be determined by order of return. Each
status parameter (except for the last parameter) is terminated
with a comma (','). The last parameter has the standard
message termination sequence ('cr''lf']).
Most of the data returned is formatted the same way as that
returned by any single command status request (refer to
Section A.3.2 for examples).
Where: 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description
(Note 1)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Modulator RF Output
(ref. 'RF_' command).
Modulator IF Frequency
(ref. 'MF_' command).
Modulator Rate
(ref. 'MR_' command).
Modulator Preset A
(ref. 'ARMA_' command).
Modulator Preset B
(ref. 'ARMB_' command).
Modulator Preset C
(ref. 'ARMC_' command).
Modulator Preset D
(ref. 'ARMD_' command).
Modulator Preset V
(ref. 'ARMV_' command).
Modulator Power Offset
(ref. 'MPO_' command).
Modulator Output PWR
(ref. 'MOP_' command).
Scrambler Enable
(ref. 'SE_' command).
Differential Encoder Enable
(ref. 'DENC_' command).
Modulator Type
(ref. 'MT_' command).
Modulator Encoder Type
(ref. 'MET_' command).
TX BPSK Data Ordering
(ref. 'TDA_' command).
Carrier Only Mode ON/OFF.
p1 = n, where 'n' is '0' (OFF) or '1' (ON).
p2 = nnn.nnnn, IF frequency in MHz.
p3 = nnnn_mmm.mmm, code rate/data rate in kbps.
p4 = nnnn_mmm.mmm, code rate/data rate in kbps.
p5 = nnnn_mmm.mmm, code rate/data rate in kbps.
p6 = nnnn_mmm.mmm, code rate/data rate in kbps.
p7 = nnnn_mmm.mmm, code rate/data rate in kbps.
p8 = nnnn_mmm.mmm, code rate/data rate in kbps.
p9 = snn.n, modulator power offset in dB.
p10 = snn.n, transmitter output power level in dBm.
p11 = n, where 'n' is '0' (OFF) or '1' (ON).
p12 = n, where 'n' is '0' (OFF) or '1' (ON).
p13 = n, where 'n' is '0' (EFD), '1' (INTL), '2'(CSC), '3' (FDC),
or '4' (SDM51).
p14 = n, where 'n' is '0' (SEQ) or '1' (VIT).
p15 = n, where 'n' is '0' (NRM), '1' (INV).
p16 = n, where 'n' is '0' (OFF) or '1' (ON).
A–27