Comtech EF Data SNM-1010L User Manual
Page 232
SNM-1010L Data/Control Modem
Revision 0
Remote Control Channel Commands/Responses
MN/SNM1010L.OM
Character e: Demodulator fault status character 2.
Bit 6 = 1 always.
Bit 5 = IF Synthesizer Lock.
Bit 4 = I Channel.
Bit 3 = Q Channel.
Bit 2 = Descrambler.
Bit 1 = BER threshold.
Bit 0 = reserved.
Note: In RX Continuous mode only.
Character f: Demodulator fault status character 3.
Bit 6 = 1 always.
Bit 5 = reserved.
Bit 4 = reserved.
Bit 3 = reserved.
Bit 2 = reserved.
Bit 1 = reserved.
Bit 0 = reserved.
Character g: Interface transmit side faults character 1.
Bit 6 = 1 always.
Bit 5 = reserved.
Bit 4 = reserved.
Bit 3 through Bit 0 = Binary representation (0 to 10)
of the number of interface transmit side stored faults.
Character h: Interface transmit side faults character 2.
Bit 6 = 1 always.
Bit 5 = Selected Transmit Clock Activity.
Bit 4 = reserved.
Bit 3 = reserved.
Bit 2 = reserved.
Bit 1 = reserved.
Bit 0 = reserved.
Note: In TX Burst mode only.
Character i: Interface receive side faults character 1.
Bit 6 = 1 always.
Bit 5 = reserved.
Bit 4 = reserved.
Bit 3 through Bit 0 = Binary representation (0 to 10)
of the number of interface receive side stored faults.
Character j: Interface receive side faults character 2.
Bit 6 = 1 always.
Bit 5 = Selected Buffer Clock Activity.
Bit 4 = Buffer Underflow.
Bit 3 = Buffer Overflow.
Bit 2 = reserved.
Bit 1 = reserved.
Bit 0 = reserved.
Note: In RX Continuous mode only.
Character k: Common equipment fault status character 1.
Bit 6 = 1 always.
Bit 5 = Monitor and Control Module.
Bit 4 = Interface Module.
Bit 3 through Bit 0 = Binary representation (0 to 10)
of the number of common equipment stored faults.
Character l: Common equipment fault status character 2.
A–34