Comtech EF Data SNM-1010L - Manual (Page 71)

SNM-1010L Data/Control Modem Revision 0
Front Panel Operation MN/SNM1010L.OM
3.4.1.3.7 CONFIGURATION:INTERFACE:INTRFC LOOP TIMING
INTRFC LOOP TIMING
OFF
Displays the current INTRFC Loop Timing, either On or Off.
Upon entry, the current INTRFC Loop Timing is displayed. Press [
↑] or [↓] to make the
selection. Press [ENTER] to execute the change.
3.4.1.3.8 CONFIGURATION:INTERFACE:BUFFER SIZE
BUFFER SIZE
384 BITS
Sets the size of the buffer, 32 to 262144 bits, 1 to 99 mS , or 0 (Bypass)
Upon entry, the current buffer length is displayed. Press [
↑] or [↓] to select the desired
buffer size. The buffer size is displayed in seconds or bits. Enter the Utility Interface menu
to change the buffer units to seconds or bits.
• If selecting seconds, choose from 1 to 99 ms, in increments of 1 ms,
or 0 (Bypass).
• If selecting bits, choose from 32 to 262144 bits, in increments of 16 bits.
• Press [ENTER] to execute the change.
Note: To have the modem calculate the plesiochronous shift, set the buffer units to ms.
When a specific buffer depth is desired, set the buffer units to bits. Select bits or ms from
the Utility Interface menu.
3.4.1.3.9 CONFIGURATION:INTERFACE:BUFFER CENTER
BUFFER CENTER
YES/NO
This configuration function is used to center the buffer. Choosing YES centers the buffer.
Press twice to center the buffer.
3–23