Comtech EF Data SNM-1010L - Manual (Page 227)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
(Note 1)
(Note 1)
(Note 1)
(Note 3)
(Note 2)
35
36
37
38
39
40
41
42
43
thru
55
56
57
Transmit Clock Phase
(ref. 'TCP_' command).
Buffer Clock Source
(ref. 'BC_' command).
Receive Clock Phase
(ref. 'RCP_' command).
Baseband Loopback
(ref. 'BBL_' command).
Interface Buffer Prog
(ref. 'IBP_' command).
Interface Buffer Size
(ref. 'IBS_' command).
Modem Operation Mode
(ref. 'MOM_' command).
Modem Remote/Local Mode.
Not valid.
Transmit Mode Selection
(ref. 'TXM_' command).
Modulator Preamble Selection
(ref. 'MPRE_' command).
p35 = n, where 'n' is '0' (NRM), '1' (INV), or '2' (AUTO).
p36 = n, where 'n' is '0' (INT), '1' (REF), '2' (EXT), or '3'
(SAT).
p37 = n, where 'n' is '0' (NRM) or '1' (INV).
p38 = n, where 'n' is '0' (OFF) or '1' (ON).
p39 = n, where 'n' is '0' (BITS) or '1' (MS).
p40 = nnnnnn, buffer size in bits or milliseconds.
p41 = n, where 'n' is '1' (TX_ONLY), '2' (RX_ONLY), or '3'
(DUPLEX).
p42 = n, where 'n' is '0' (LOCAL) or '1' (REMOTE).
p56 = n, where 'n' is '1' (BURST) or '2' (CONTINUOUS).
p57 = n, where 'n' is '1' (PREAMBLE) or '2' (PREAMBLE
2).
A–29