Comtech EF Data SNM-1010L - Manual (Page 56)

SNM-1010L Data/Control Modem Revision 0
Front Panel Operation MN/SNM1010L.OM
3.4.1.1.2 CONFIGURATION:MODULATOR:TX-IF FREQUENCY
TX-IF FREQUENCY
1200.000000 MHz
Displays the modulator TX IF frequency between 950 to 1750 MHz, in 100 Hz steps.
The DAC sets this from the OCF setting. Refer to paragraph 4.3.6.
Upon entry, the current transmitter frequency is displayed with the flashing cursor on the
first character. Press [
← ] or [→] to move the flashing cursor, and [↑ ] or [↓ ] to increase
or decrease the digit at the flashing cursor. Press to execute the change.
CONFIGURATION:MODULATOR:TX TERMINAL FREQ
(FUTURE OPTION)
TX TERMINAL FREQ
5845.0000 MHz
Range dependent on LO and Mix. Refer to Utility menus.
3.4.1.1.3 CONFIGURATION:MODULATOR:TX-IF OUTPUT
TX-IF OUTPUT
ON
Displays the modulator output status, either On or Off.
3–8