Interface commands/responses, A.3.1 interface commands/responses – Comtech EF Data SNM-1010L User Manual
Page 207
SNM-1010L Data/Control Modem
Revision 0
Remote Control Channel Commands/Responses
MN/SNM1010L.OM
A.3.1
Interface Commands/Responses
Interface Transmit
Overhead Type
Command:
Response:
Status:
Response:
MC ITOT_xxxxx'cr'
ITOT_xxxxx'cr''lf']
MC ITOT_'cr'
ITOT_xxxxx'cr''lf']
Where: xxxxx = NONE or AUPC.
Interface Receive
Overhead Type
Command:
Response:
Status:
Response:
MC IROT_xxxxx'cr'
IROT_xxxxx'cr''lf']
MC IROT_'cr'
IROT_xxxxx'cr''lf']
Where: xxxxx = NONE or AUPC.
TX Driver Type
Command:
Response:
Status:
Response:
MC TXDR_xxxxx'cr'
TXDR_xxxxx'cr''lf']
MC TXDR_'cr'
TXDR_xxxxx'cr''lf']
Where: xxxxx = V35, RS422, or RS232.
RX Driver Type
Command:
Response:
Status:
Response:
MC RXDR_xxxxx'cr'
RXDR_xxxxx'cr''lf']
MC RXDR_'cr'
RXDR_xxxxx'cr''lf']
Where: xxxxx = V35, RS422, or RS232.
Transmit Clock
Command:
Response:
Status:
Response:
MC TC_xxx'cr'
TC_xxx'cr''lf']
MC TC_'cr'
TC_xxx'cr''lf']
Where:
xxx = INT (Internal SCT Clock), EXT (External TX
Terrestrial Clock), or SAT (Receive Satellite Clock).
External Clock-Reference
Frequency
Command:
Response:
Status:
Response:
MC ERF_nnnnn.n'cr'
ERF_nnnnn.n'cr''lf']
MC ERF_'cr'
ERF_nnnnn.n'cr''lf']
Where: nnnnn.n = 8.0 to 10000.0 (external clock frequency in
kHz).
Transmit Clock Phase
Command:
Response:
Status:
Response:
MC TCP_xxxx'cr'
TCP_xxxx'cr''lf']
MC TCP_'cr'
TCP_xxxx'cr''lf']
Where:
In TX Burst mode, xxxx = NRM (Normal Clock Phasing) or
INV (Inverted Clock Phasing).
In TX Continuous mode, xxxx = NRM (Normal Clock
Phasing), INV (Inverted Clock Phasing), or AUTO
(Automatic Clock Phasing).
Buffer Clock
Command:
Response:
Status:
Response:
MC BC_xxx'cr'
BC_xxx'cr''lf']
MC BC_'cr'
BC_xxx'cr''lf']
Where: xxx = INT (Internal SCT Clock), EXT (External TX
Terrestrial Clock), SAT (Receive Satellite Clock), or REF
(External Reference Clock).
Note: In RX Continuous mode only.
Receive Clock Phase
Command:
Response:
Status:
Response:
MC RCP_xxxx'cr'
RCP_xxxx'cr''lf']
MC RCP_'cr'
RCP_xxxx'cr''lf']
Where: xxxx = NRM (normal clock phasing) or INV (inverted
clock phasing).
Baseband Loopback
Command:
Response:
Status:
Response:
MC BBL_xxx'cr'
BBL_xxx'cr''lf']
MC BBL_'cr'
BBL_xxx'cr''lf']
Where: xxx = ON or OFF.
A–9