Comtech EF Data SNM-1010L - Manual (Page 219)

SNM-1010L Data/Control Modem Revision 0
Remote Control Channel Commands/Responses MN/SNM1010L.OM
A.7 Error Performance Status
Raw BER Status:
Response:
MC RBER_'cr'
RBER_xm.mE-ee'cr''lf']
Where:
x = < or > (data modifier to indicate that the error rate is less
than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the error rate cannot be
calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.
Corrected BER Status:
Response:
MC CBER_'cr'
CBER_xm.mE-ee'cr''lf']
Where:
x = < or > (data modifier to indicate that the error rate is less
than or greater than the returned value).
m.m = 1.0 to 9.9 (error rate mantissa).
ee = 1 to 99 (error rate exponent).
Notes:
1. The 'x' (< or >) parameter is only returned if the error
rate has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the error rate cannot be
calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.
A–21