Altera Arria 10 Avalon-ST User Manual
Page 73

Qword alignment applies to all types of request TLPs with data, including the following TLPs:
• Memory writes
• Configuration writes
• I/O writes
The alignment of the request TLP depends on bit 2 of the request address. For completion TLPs with data,
alignment depends on bit 2 of the
lower address
field. This bit is always 0 (aligned to qword boundary)
for completion with data TLPs that are for configuration read or I/O read requests.
Figure 6-2: Qword Alignment
The following figure shows how an address that is not qword aligned, 0x4, is stored in memory. The byte
enables only qualify data that is being written. This means that the byte enables are undefined for 0x0–
0x3. This example corresponds to 64-Bit Avalon-ST rx_st_data
TLPs with Non-Qword Aligned Address.
.
.
.
0x0
0x8
0x10
0x18
Header
Addr = 0x4
64 bits
PCB Memory
Valid Data
Valid Data
The following table shows the byte ordering for header and data packets.
Table 6-3: Mapping Avalon-ST Packets to PCI Express TLPs
Packet
TLP
Header0
pcie_hdr_byte0, pcie_hdr _byte1, pcie_hdr _byte2, pcie_hdr _byte3
Header1
pcie_hdr _byte4, pcie_hdr _byte5, pcie_hdr byte6, pcie_hdr _byte7
Header2
pcie_hdr _byte8, pcie_hdr _byte9, pcie_hdr _byte10, pcie_hdr _byte11
Header3
pcie_hdr _byte12, pcie_hdr _byte13, header_byte14, pcie_hdr _byte15
Data0
pcie_data_byte3, pcie_data_byte2, pcie_data_byte1, pcie_data_byte0
Data1
pcie_data_byte7, pcie_data_byte6, pcie_data_byte5, pcie_data_byte4
Data2
pcie_data_byte11, pcie_data_byte10, pcie_data_byte9, pcie_data_byte8
UG-01145_avst
2015.05.04
Data Alignment and Timing for the 64‑Bit Avalon‑ST RX Interface
6-7
Interfaces and Signal Descriptions
Altera Corporation