Altera Arria 10 Avalon-ST - Manual (Page 35)

Understanding Simulation Log File Generation
Starting with the Quartus II 14.0 software release, simulation automatically creates a log file, altpcie_
monitor__dlhip_tlp_file_log.log in your simulation directory.
Table 3-3: Sample Simulation Log File Entries
Time TLP Type Payload
(Bytes)
TLP Header
17989 RX CfgRd0 0004 04000001_0000000F_01080008
17989 RX MRd 0000 00000000_00000000_01080000
18021 RX CfgRd0 0004 04000001_0000010F_0108002C
18053 RX CfgRd0 0004 04000001_0000030F_0108003C
18085 RX MRd 0000 00000000_00000000_0108000C
Simulating the Example Design
Follow these steps to simulate the Qsys system using ModelSim:
1. In a terminal window, change to the
/top/testbench/mentor
directory.
2. Start the ModelSim simulator by typing
vsim
.
3. To compile the simulation, type the following commands in the terminal window:
•
source msim_setup.tcl
(The
msim_setup.tcl
file defines aliases.
•
ld_debug
(The
ld_debug
command argument stops optimizations, improving visibility in the
ModelSim waveforms. )
The following figure shows the design hierarchy for the Configuration Space Bypass Example Design after
compilation.
Figure 3-3: Design Hierarchy for the Configuration Space Bypass Example Design for 256-Bit Avalon-ST
Interface
UG-01145_avst
2014.08.18
Understanding Simulation Log File Generation 3-5
Getting Started with the Configuration Space Bypass Mode Qsys Example Design Altera Corporation
Send Feedback