Pilz PSSnet SHL 8T MRP - Manual (Page 96)

CLI Commands: Base
96
4.4 Management Commands
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.4.28 snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address
is the associated community SNMP packet sending address and is used
along with the client IP address value to denote a range of IP addresses from
which SNMP clients may use that community to access the device. A value
of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP Address. A value of 0.0.0.0 will allow
access from any IP address. The name is the applicable community name.
Default
0.0.0.0
Format
snmp-server community ipmask < ipmask>
Mode
Global Config
U no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0.
The name is the applicable community name. The community name may
be up to 32 alphanumeric characters.
Format
no snmp-server community ipmask < name>
Mode
Global Config