Pilz PSSnet SHL 8T MRP - Manual (Page 277)

CLI Commands: Switching
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
5.1 Spanning Tree Commands
277
5.1.19 spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree in-
stance. The instance is a number that corresponds to the desired ex-
isting multiple spanning tree instance. The priority value is a number within a
range of 0 to 61440 in increments of 4096.
This command accepts the value 0 for the mstid.
If 0 (defined as the default CIST ID) is passed as the , then this
command sets the Bridge Priority parameter to a new value for the common
and internal spanning tree. The bridge priority value again is a number within
a range of 0 to 61440. The twelve least significant bits will be masked
according to the 802.1s specification. This will cause the priority to be
rounded down to the next lower valid priority.
Default
32768
Format
spanning-tree mst priority <0-61440>
Mode
Global Config
U no spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning
tree instance to the default value, i.e. 32768. The instance is a
number that corresponds to the desired existing multiple spanning tree
instance.
This command accepts the value 0 for the mstid.
If 0 (defined as the default CIST ID) is passed as the , then this
command sets the Bridge Priority parameter for the common and internal
spanning tree to the default value, i.e. 32768.
Format
spanning-tree mst priority
Mode
Global Config