56 storm-control egress-limit, 57 storm-control ingress-limit, 58 storm-control ingress-mode – Pilz PSSnet SHL 8T MRP User Manual
Page 169: 56storm-control egress-limit, 57storm-control ingress-limit, 58storm-control ingress-mode
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.6 Device Configuration Commands
169
4.6.56 storm-control egress-limit
Sets the egress rate limit in kbit/s. "0" means: no limit .
Format
storm-control egress-limit
Mode
Interface Config
4.6.57 storm-control ingress-limit
Sets the ingress rate limit in kbit/s. "0" means: no limit.
Format
storm-control ingress-limit
Mode
Interface Config
4.6.58 storm-control ingress-mode
This command sets the frame type for the ingress limiter to:
All, BC, BC+MC, BC+MC+uUC .
Format
storm-control ingress-mode {all | bc | mc+bc |
uuc+mc+bc}
Mode
Interface Config
This manual is related to the following products: