Pilz PSSnet SHL 8T MRP - Manual (Page 136)

136
4.6 Device Configuration Commands
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.6.18 set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the sys-
tem. The Group Membership Interval time is the amount of time in seconds
that a switch will wait for a report from a particular group on a particular inter-
face before deleting the interface from the entry. This value must be greater
than the IGMP Maximum Response time value. The range is 3 to
3600 seconds.
Default
260
Format
set igmp groupmembershipinterval <3-3600>
Mode
Global Config
U no set igmp groupmembershipinterval
This command sets the IGMP Group Membership Interval time on the
system to 260 seconds.
Format
no set igmp groupmembershipinterval
Mode
Global Config