9 spanning-tree auto-edgeport – Pilz PSSnet SHL 8T MRP User Manual
Page 266

CLI Commands: Switching
266
5.1 Spanning Tree Commands
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
5.1.9 spanning-tree auto-edgeport
This command specifies that this port is an Edge Port within the common and
internal spanning tree. This will allow this port to transition to Forwarding
State without delay.
Format
spanning-tree auto-edgeport
Mode
Interface Config
U
no spanning-tree auto-edgeport
This command specifies that this port is not an Edge Port within the com-
mon and internal spanning tree.
Format
no spanning-tree auto-edgeport
Mode
Interface Config
This manual is related to the following products: