Pilz PSSnet SHL 8T MRP User Manual
Page 27

Quick Start up
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
2.2 System Info and System Setup
27
users passwd name> (in Global Config) Allows the user to set passwords or change passwords copy system:running- config nvram:startup-config (in Privileged EXEC) This will save passwords and all other changes to the logout (in User EXEC and Privileged Logs the user out of the switch Command Details Table 10: Quick Start up User Account Management
needed to login
A prompt will appear after the command is entered
requesting the users old password. In the absence of an
old password leave the area blank. The operator must
press enter to execute the command.
The system then prompts the user for a new password
then a prompt to confirm the new password. If the new
password and the confirmed password match a message
will be displayed.
User password should not be more than eight characters
in length.
device.
If you do not save the configuration by doing this com-
mand, all configurations will be lost when a power cycle is
performed on the switch or when the switch is reset.
EXEC)