Pilz PSSnet SHL 8T MRP - Manual (Page 79)

CLI Commands: Base
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.4 Management Commands
79
4.4.8 network parms
This command sets the IP Address, subnet mask and gateway of the router.
The IP Address and the gateway must be on the same subnet.
Format
network parms [gateway]
Mode
Privileged EXEC
4.4.9 network protocol
This command specifies the network configuration protocol to be used. If you
modify this value change is effective immediately. The parameter bootp in-
dicates that the switch periodically sends requests to a Bootstrap Protocol
(BootP) server or a DHCP server until a response is received. none indicates
that the switch should be manually configured with IP information.
Independently of the BootP and DHCP settings, HiDiscovery can be
configured as an additional protocol.
Default
DHCP
Format
network protocol {none | bootp | dhcp | hidiscovery
{off | read-only | read-write}}
Mode
Privileged EXEC