22 set igmp maxresponse, 22set igmp maxresponse – Pilz PSSnet SHL 8T MRP User Manual
Page 139

PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.6 Device Configuration Commands
139
4.6.22 set igmp maxresponse
This command sets the IGMP Maximum Response time on the system. The
Maximum Response time is the amount of time in seconds that a switch will
wait after sending a query in response to a received leave message, before
deleting the multicast group received in the leave message. If the switch re-
ceives a report in response to the query within the maxresponse time, then
the multicast group is not deleted. This value must be less than the IGMP
Query Interval time value. The range is 1 to 3598 seconds.
Default
10
Format
set igmp maxresponse <1-3598>
Mode
Global Config
Note: the IGMP Querier's max. response time was also set. It is always the
same value as the IGMP Snooping max. response time.
U
no set igmp maxresponse
This command sets the IGMP Maximum Response time on the system to
10 seconds.
Format
no set igmp maxresponse
Mode
Global Config