1 quick starting the switch, Quick starting the switch – Pilz PSSnet SHL 8T MRP User Manual
Page 24

Quick Start up
24
2.1 Quick Starting the Switch
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
2.1 Quick Starting the Switch
D
Read the device Installation Guide for the connectivity procedure. In-band
connectivity allows access to the software locally or from a remote work-
station. The device must be configured with IP information (IP address,
subnet mask, and default gateway).
D
Turn the Power ON.
D
Allow the device to load the software until the login prompt appears. The
device initial state is called the default mode.
D
When the prompt asks for operator login, execute the following steps:
D
Type the word admin in the login area. Since a number of the Quick
Setup commands require administrator account rights, CLI suggests
logging into an administrator account.
D
Enter the state on delivery password private.
D
Press the enter key.
D
The CLI User EXEC prompt will be displayed.
User EXEC prompt:
(Hirschmann Product) >
D
Use “enable” to switch to the Privileged EXEC mode from User EXEC.
Privileged EXEC prompt:
(Hirschmann Product) #
D
Use “configure” to switch to the Global Config mode from Privileged
EXEC.
Global Config prompt:
(Hirschmann Product) (Config)#
D
Use “exit” to return to the previous mode.