Pilz PSSnet SHL 8T MRP - Manual (Page 15)

Command Structure
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
1.1 Format
15
1.1.2 Parameters
Parameters are order dependent.
Parameters may be mandatory values, optional values, choices, or a combi-
nation.
D . The <> angle brackets indicate that a mandatory param-
eter is to be entered in place of the brackets and text inside them.
D [parameter]. The [] square brackets indicate that an optional parame-
ter may be entered in place of the brackets and text inside them.
D choice1 | choice2. The | indicates that only one of the parameters
should be entered.
D The {} curly braces indicate that a parameter must be chosen from the list
of choices.
1.1.3 Values
ipaddr This parameter is a valid IP address, made
up of four decimal bytes ranging from 0 to
255. The default for all IP parameters con-
sists of zeros (that is, 0.0.0.1). The inter-
face IP address of 0.0.0.0 is invalid. In
some cases, the IP address can also be
entered as a 32-bit number.
macaddr The MAC address format is six hexadeci-
mal numbers separated by colons, for
example 00:06:29:32:81:40.
areaid Area IDs may be entered in dotted-decimal
notation (for example, 0.0.0.1). An area ID
of 0.0.0.0 is reserved for the backbone.
Area IDs have the same form as IP
addresses, but are distinct from IP
addresses. The IP network number of the
sub-netted network may be used for the
area ID.