1 show ring-coupling – Pilz PSSnet SHL 8T MRP User Manual
Page 300

CLI Commands: Switching
300
5.5 Redundant Coupling
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
5.5.1 show ring-coupling
This command displays the settings and states of the network coupling / ring
coupling.
To set up a new Ring Coupling configuration when no configuration is cur-
rently present (e. g., after a clear command), always set the local port first.
Please refer to: ring-coupling port local
The following details are displayed on execution of the command.
Format
show ring-coupling
Mode
Privileged EXEC and User EXEC
config
Display the Ring Coupling's configuration
– single
– dual-master-inband
– dual-master-outband
– dual-slave-inband
– dual-slave-outband.
info
Display information about the Ring Coupling's states:
– configuration failure,
– Extended diagnosis,
– redundancy guaranteed.
net-coupling
Display the Ring Coupling's ring/network coupling setting (network/
ring-only).
operation
Display the Ring Coupling's operation setting
– on
– off
partner IP
Display the switch's Ring Coupling partner IP address (only valid for
remote configurations).