Pilz PSSnet SHL 8T MRP - Manual (Page 257)

CLI Commands: Switching
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
5.1 Spanning Tree Commands
257
Bridge Forward Delay
Configured value.
Bridge Hold Time
Minimum time between transmission of Configuration Bridge Protocol
Data Units (BPDUs)
Rstp Mrp Mode
Rapid spanning tree mrp (Media Redundancy Protocol) mode
(Enabled/Disabled)
Rstp Mrp configuration error
Configuration error in Rapid spanning tree mrp (Media Redundancy
Protocol) (No/Yes)
5.1.2 show spanning-tree interface
This command displays the settings and parameters for a specific switch port
within the common and internal spanning tree. The is the desired
switch port. The following details are displayed on execution of the com-
mand.
Format
show spanning-tree interface <slot/port>
Mode
Privileged EXEC and User EXEC
Port mode
Enabled or disabled.
Port Up Time Since Counters Last Cleared
Time since port was reset, displayed in days, hours, minutes, and
seconds.
STP BPDUs Transmitted
Spanning Tree Protocol Bridge Protocol Data Units sent