Pilz PSSnet SHL 8T MRP - Manual (Page 303)

CLI Commands: Switching
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
5.5 Redundant Coupling
303
5.5.3 ring-coupling config
This command sets the Ring Coupling configuration.
Possible values are:
D single Configure the Ring Coupling's basic setting to single (both cou-
pling ports are local to the switch, switch performs master and slave func-
tions).
D dual-master-inband Configure the Ring Coupling's basic setting to
dual-master-inband (2nd coupling port is on a remote switch, local switch
is master, communication over network).
D dual-master-outband Configure the Ring Coupling's basic setting to
dual-master-outband (2nd coupling port is on a remote switch, local
switch is master, communication over dedicated control port).
D dual-slave-inband Configure the Ring Coupling's basic setting to
dual-slave-inband (2nd coupling port is on a remote switch, local switch is
slave, communication over network).
D dual-slave-outband Configure the Ring Coupling's basic setting to
dual-slave-outband (2nd coupling port is on a remote switch, local switch
is slave, communication over dedicated control port).
D dmi Abbreviation for dual-master-inband.
D dmo Abbreviation for dual-master-outband.
D dsi Abbreviation for dual-slave-inband.
D dso Abbreviation for dual-slave-outband.
Default
none
Format
ring-coupling conf <{single|dual-master-
inband|dual-master-outband|dual-slave-inband|dual-
slave-outband|dmi|dmo|dsi|dso}>
Mode
Global Config