Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 77)

Beake mixing
Brake 2 "ON"
Beake mixing
Brake 3 "ON"
Beake mixing
Brake 2&3 "ON"
Beake mixing Beake mixing Beake mixing
Setup items
Mode (Function On/Off)
Brake return amount
Delay amount
Cycle speed
Duty ratio
77
Fu
n
c
tio
n
A.B.S Function
Setting items other than trigger point and steering mixing can be adjusted independently.
Use PS1~PS5 to switch the A.B.S. function ON/OFF.
See the function select switch function. (p.99)
Switch setting
The brake return amount, delay amount and cycle speed can be controlled with digital
trim DT1~DT5 or digital dial DL1 etc. with the function select dial function. (p.101)
Dial / Trim Setting
- Basic setting
Brake return: Approx. 30% (If this value is too high, the braking distance will increase.)
Cycle speed: 5~7
Duty ratio: 0 (When grip is low: - side, when grip is high: + side)
Delay : 10~15%
Trigger point: Approx. 70%
Steering mixing: Off
- When the wheels lock, or the car spins, when the brakes are applied fully
Brake return: Increase from 30%
Duty ratio: Shift from 0 to - side (-1, -2, -3)
Delay : Reduce the delay
- When the braking effect is poor and the braking distance is long when the brakes are
applied fully
Brake return: Decrease from 30%
Duty ratio: Shift from 0 to + side (+1, +2, +3)
DLY: Increase the delay
Example of A.B.S. function setting when S9353HV used
(There will be a slight difference depending on the state of the linkage.)
ABS can be independently set for the brakes which are controlled by the Brake2 and
Brake3 (3rd CH and 4th CH) by using the brake mixing function described on page 80.
1/5 scale car and other independent brakes and ABS