Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS User Manual

Page 59

Setup items
Typ :Forward side curve selection
Rate :Forward side rate
Trigger point :Curve switching point
Brake-EXP :Brake side rate
Setup item selection
- Select by (JOG) button up or down operation.
Curve type Select button
- Select with the (+) or (-) buttons.

Fu
n

tio

Throttle curve

Switching point
A vertical cursor line that shows

the curve switching point is dis-
played on the setup screen graph.

(Preparation)

- Select the "Type" to be set by (JOG) button operation.

With the plus (+) or minus (-) buttons, select "VTR"

Adjustment method for VTR curve

Adjustment range
Rate :-100 ~ 0 ~ +100%
Trigger point :20 ~ 80%
Brake-EXP :-100 ~ 0 ~ +100%

For the VTR curve, only the
high side can be set. The
b r a k e b e c o m e s t h e E X P
curve.

Adjustment buttons
Adjust with the (+) and (-) but-

tons.

- Return to the initial value by

pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).

Initial value:

Rate and Brake-EXP "0"
Trigger point "50"

Forward side adjustment

Select the "Rate" to be set by (JOG) button operation. Use the plus (+) button to adjust for

a faster response. Use the minus (-) button for a slower or mild response. -Plus (+) button-

the higher the number goes on the positive side, the faster the response will be at center of

throttle response. -Minus (-) button- the higher the number goes on the negative side, the

milder or softer it is in the center of the throttle response.

Curve switching point adjustment

Select the "Trigger point" to be set by (JOG) button opera-

tion. Use the plus (+) or minus (-) buttons to move the point

you prefer. This gives you the opportunity of switching the

curve point in relation to the throttle trigger position.

Brake side adjustment

Select the "Brake EXP" to be set by (JOG) button operation.

Use the plus (+) button to adjust for a faster brake response

or use the minus (-) button for a slower or milder brake re-

sponse. When the setting item "Quick or mild" is selected

and the (JOG) button is pressed when the rate is other than

"0", quick/mild are reversed.

When ending setting, return to the curve screen by pressing the (END) button.