Futaba 4PX 2.4GHz FASST T-FHSS S-FHSS - Manual (Page 157)

157
Reference
Caution
Reference
Specifications
Transmitter T4PX
(Wheel system, 4 channels)
- Transmitting frequencies 2.4GHz band
- Futaba T-FHSS(R304SB/SB-E )/S-FHSS(R2104GF, R204GF-E/FASST-C2(R614FS/
FF-E/FF, R604FS/FS-E )
- Power requirement
(Ni-MH battery) NT5F1700B Ni-MH battery (6V)
(LiFe battery) FT2F1700BV2 (6.6V)
- Current drain 300mA or less (When the T-FHSS, Vibration off, back lighting on)
7UDQVPLWWLQJDQQWHQQDȜGLSROH
Receiver R304SB / R304SB-E: (T-FHSS system, 4 channels)
Receiving frequency: 2.4GHz band
Power requirement: 4.8V~7.4V battery / 3.5 ~ 8.4V useable (Dry cell battery cannot be used.)
System: T-FHSS system (auto detection)
Size:
R304SB :1.38x0.91x0.33 "[[PPH[FOXGLQJDSURMHFWLRQSDUW
R304SB-E :1.38x0.91x0.49 ”[[PPH[FOXGLQJDSURMHFWLRQSDUW
Weight: R304SB :0.23oz. (6.6g) / R304SB-E :0.24oz. (6.7g)
6SHFL¿FDWLRQVDQGUDWLQJVDUHVXEMHFWWRFKDQJHZLWKRXWSULRUQRWLFH
When using the 4PX in the "Digital servo" type, always use it under the following conditions:
Servos :Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
Transmitter mode :Digital servo type(See p.39 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In ad-
dition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the products
of other companies.
In addition, the FSU Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the trans-
mitter.
When using analog servos, always switch the 4PX servo type to the "Analog servo" mode.
Transmitter mode :Analog servo type(See p.39 for setting method.)
Receiver’s battery :Matched to the ratings of the receiver and connected servo.
The set cannot operate in the "Digital servo" type. Operation in this type will cause trouble with the servo and other equipment.
Digital servos (including BLS Series brushless servos) can also be used in the "Analog servo" type.